Wheel builder

Wheel Dimensioning Engine

Workshop tools ↗
Library:11 Rims|16 Hubs
GitHub
⚡

Wheel CAD Engine2D CAD & 3D

High-Fidelity Bicycle Wheel Geometry & Technical Cross-Section Inspector

🧩

Selected Components

Synced Across Tabs
Hub ModelHope Pro 5 Rear 135 mm — 32 holes — 6-Bolt
Rim ModelBrompton G Line 20" (406), 32-hole rear — eyelets, Presta

Assembly Parameters

32
Share BuildRemembered in this tab · copy a link to share

The 3D view will load when visible.

Cyan: heads-out · Green: heads-in (head / elbow)

View settings
EXPLODE HUB0%

Engine Output MetricsCalculated

Left / non-drive — traditional--mmNearest whole millimetre: -- mm
Right / drive — traditional--mmNearest whole millimetre: -- mm
Estimated 3D path — millimetres
Spoke group3D shaftExtra from bendsTraditional + allowance

The bend allowance compares the shaft path with its own straight chord, excluding the manufactured J-bend. Head and elbow seating against the flange are not simulated. These are geometric estimates, not validated purchase lengths. Final stock length depends on measured ERD and nipple engagement.

Input sensitivity

Change in traditional spoke length when one input increases by 1 mm. Includes offsets and Auto rim orientation. These are input responses, not measurement tolerances or confidence intervals.

Length change (mm) for +1 mm input
InputLeftRight
Effective Flange Offset
-- mm-- mm
Lateral Bracing Angle
--°--°
Rim Wrap Angle (2D)
--°--°
Total Rim Angle (3D)
--°--°
Flange Exit Angle
--°--°
Rotational Offset (Theta)
--°--°

Physics Analysis & Balance

Tension Balance-- % : 100 %
Lateral force equilibrium · equal side counts
Left--%
Right100%